FAQ EZ15 Pull Line Blower

EZ15 Pull Line Blower

Is the EZ15 pull line blower suitable for flexible pipes / corrugated pipes?

Yes, the EZ15 pull line blower can also be used with flexible pipes or corrugated pipes.

Can the EZ15 cord injection device also be used with occupied pipes?

The EZ15 cord injection device is not intended for use with occupied pipes.

Can the cable pull cord be reused with the EZ15 pull line blower?

No, the cord reel is specially made for the container of the appliance.

How much air pressure must the compressor build up for optimum use of the EZ15 pull line blower?

8 bar air pressure would be ideal. For a compressor with 10 bar, the pressure regulator should be reduced to 8 bar.

What air volume capacity should the compressor have for using the EZ15 pull line blower?

For pipes with a diameter of up to 8 mm, approx. 85 liters/min is required; for pipes with a diameter of 8 mm or more, we recommend a capacity of at least 200 liters/min.

For which pipe dimensions can the EZ15 pull line blower be used?

The EZ15 pull line blower is suitable for pipes with an internal diameter of Ø 4 to 20 mm.

Is the EZ15 pull line blower suitable for cleaning pipes?

Yes, this is possible with the use of Lubriballs.

Is a special compressor required to use the EZ15 pull line blower?

No, a commercially available small compressor is sufficient.

Is the EZ15 pull line blower suitable for pipes in rolled condition?

Yes, the EZ15 pull line blower enables a cord to be inserted into a pipe collar.